Tamiya TXT-2 Servo Install

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 2 roky by admin

170 Zobrazení

I lost some footage making this video, had some tips that did not make it into this video.
On the front servo mounts, the BB3 3x12mm machine screws (fine thread) go through the F3 spacers with BE6 3mm Internally-toothed washer (should look like there in enough space between the F3 & bumper guard to slip in a micro SD card, it will not go in more than that, DO NOT OVER TIGHTEN THOSE SCREWS!!!!) which then pass through the axle guard, seems like your left with @ 8mm of thread to go into the F6 servo mounts. The same is true for the rear servo mounts if you choose to run 4WS, the BE2, 3x30mm only leave about 8mm of threads to go into the F6 servo mounts, Use Extreme Caution When Screwing in the Screws!!

I am using a HobbyWing Quicrun 880 Brushed ESC, its for dual motor monster trucks or any other dual motor rc vehicle. Bonus, it came with a cooling fan. sells for @ $34 USD

Im also using ZOSKAY 35kg high Torque Coreless Motor servo Metal Gear Digital and Stainless Steel Gear servo arduino servo for Robotic DIY,RC car (Control Angle 270°) for the front steering. @ $35 USD

For the rear steering, im using ZOSKAY servo 6V 20kg/0.09S High Speed Servo DS3218 PRO Waterproof High Torque Metal Gear Standard Digital Servo for 1/8 1/10 Scale RC Cars (Control Angle 270) @ $19 USD

Please, if i forgot something, leave a comment, they are always welcome.
Hope this puts some light on this kit if you plan on getting/building one.
As Always, Thank You For Watching!!!!!!!!!!