Puri - RC Flying Wing - Time Lapse Build

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 1 rok by

53 Zobrazení

In this video I will show you a time lapse build of the Puri RC flying wing. The Puri was presented in the September 2021 edition of the German RC magazine FMT.
On the website of the magazine you can order either a laser cut kit, a printed or a digital plan (check detailed links below).

Ordering link for the laser cut kit: https://en.shop.vth.de/holzbausatz_puri-6211949/
Ordering link for the plan: https://en.shop.vth.de/bauplan_puri_-11-3201534/
Ordering link for the build instructions: https://shop.vth.de/baubeschreibung_puri-9660bb/

Specs:
Wingspan: 650 mm
Length: 260 mm
Wing area: 8 dm2
Weight (AUW): 135 g (in my configuration)
RC functions: elevator, ailerons, motor

My configuration:
Motor: Hacker A05-13S kv3200
Prop: Hacker GWS Prop 4 x 4 HD
Battery: LemonRC 2S-350, XT-30
ESC: Hacker X-5 Pro Brushless Controller (5-10NC/2-3LiPo)
Receiver: Graupner GR-12L HoTT - 2.4 GHz, 6 channel
Servos: 2x HiTEC Servo HS-40, 20x8.6x17mm, 9,8Ncm, 4.8g

Covering film:
ORALIGHT transparent orange
ORALIGHT transparent blue
ORACOVER white
ORACOVER Hotmelt Adhesive (960)
ORACOVER Thinner for Hotmelt Adhesive (980)

Vinyl:
d-c-fix glossy black vinyl

Other material:
Screws for motor attachment to firewall: 1,7 x 6 mm (https://minischrauben.com/blech-holzschrauben-bund-linsenkopf--46195.html)
Shrinking tube to secure the control rods: diameter 1,5mm (0,5 mm shrunk). I added a drop of CA glue to be on the safe side :-)

Note: This video is not sponsored. I only recommend the stuff I used and that worked well for me.

Cutting machine:
BROTHER ScanNCut SDX1000

Camera:
Sony HDR-CX730

Microphone:
Rode NTUSB