Micro RC Monster Truck [PART 2 - OVERVIEW AND TEST]

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 3 roky by admin

155 Zobrazení

This is my Micro RC Monster Truck. I have always wanted an RC solid axle monster truck and a 3D printed RC truck. This checks both of those boxes.

It was originally going to use parts from a WLtoys P929 but they were too small. They will be used on a 1/32 build with a Spin Master Monster Jam body.

Temporarily, I am using ECX Barrage 1/24 parts. I plan on upgrading the drive train with parts from a 1/18 scale 4WD buggy so that it has open differentials. This chassis should be large enough to use axles from a 1/18 scale RC crawler as well.

The stock ECX Barrage motor is not powerful enough, even on 2s. I plan on upgrading to a 180 brushed motor. I think a 1/18 brushless combo would be too powerful.

The tires are from a 1/25 scale model truck kit from AMT. I designed the rims and 3D printed them. They are sized to work with Barrage axles but should also work with any axles that use a 7mm hex.

Everything was printed in PLA. I am going to make another using PETG. However, I have not broken any of the 3D printed rc parts yet.

When I originally printed the body it was .8mm thick. That was just too thin. It is now 1.2mm thick.

RC 3D Print Files : https://www.thingiverse.com/thing:4678571

Don’t forget to SUBSCRIBE!