3D printed RC Buggy: Body assembly

Děkujeme! Podělte se svými přáteli!

Nelíbí sa vám video. Děkujeme za zpětnou vazbu!

Vloženo před 7 roky by admin

520 Zobrazení

Assembly video on the Buggy project.
This video is about the body and a little bit of driving at the end.
Trying some new stuff so I'm sorry about the bad audio.

For those of you not familiar with it, it's an almost fully 3D printed RC vehicle in the shape of a buggy.

For the files and BOM, check out my thingiverse and youmagine pages.

Besides electronics, you will need these:
Shocks(4pcs): https://goo.gl/OgxaQy
Balls for shock(4pcs): https://goo.gl/WmuXPE
M3*250 rod(1pc)https://goo.gl/Tvu4Qk
M3x10(24pcs): https://goo.gl/E6YBhL
M3x16(50pcs): https://goo.gl/E6YBhL
M4x10(12pcs): https://goo.gl/jFbtnB
M4x20(12pcs): https://goo.gl/jFbtnB
M4x40(6pcs): https://goo.gl/jFbtnB
M4x0.7 nuts(10pcs): https://goo.gl/edLyax
Rodends(6pcs): https://goo.gl/VR3WxF
6700zz bearings(20pcs): https://goo.gl/Jdr45u

The battery I'm using is a Rhino 2S, 2350mAh.
Receiver/transmitter is Hobbyking HK-T6A
Servo is regular standard sized.

I'd like to thank my Patreon supporters:
Umurcan Görür
Blaz Repas
Arnt Ola Fjærli
Michael Henry
Krister Persson
David
Yoon Cheolhwan

If you like the projects I release, please consider helping me sustain this channel by taking a look at my patreon page.

Don't forget to share, like and subscribe if you like my content! :)

Check me out at:
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/service/crank3d
Thingiverse: http://www.thingiverse.com/MrCrankyface/designs
Youmagine: https://www.youmagine.com/mrcrankyface/designs
Patreon: http://patreon.com/Mrcrankyface
Orders/comissions: http://www.crank3d.se